[FreeNX-kNX] Error when trying to install freenx-0.5.0 with a nx 2.0.0 backend.
S. J. van Harmelen
svh at dds.nl
Fri Sep 22 12:20:47 UTC 2006
Oke... Found a solution myself. Just edited line 514 of nxloadconfig to
match the proper string, and all seems to be working fine :)
I don't think this is a nice permanent solution, but it definitly
works!!
Gr. S.
On Fri, 2006-09-22 at 11:40 +0200, S. J. van Harmelen wrote:
> Hey there!
>
> I'm trying to install freenx-0.5.0 with a nx 2.0.0 backend. All goes
> fine but when I try to run:
>
> nxsetup --install --uid 80 --gid 100 --setup-nomachine-key
>
> I get the following output:
>
> =============================================================
>
> Setting up /usr/NX/etc ...done
> Setting up /usr/NX/var/db ...done
> Setting up /var/log/nxserver.log ...done
> Setting up known_hosts and authorized_keys2 ...done
> Setting up permissions ...done
>
> ----> Testing your nxserver configuration ...
> Warning: Could not find nxviewer in /usr/NX/bin. VNC sessions won't
> work.
> Warning: Invalid value "CUPS_ETC=/etc/cups/"
> Users will not be able to enable printing.
> Warning: Invalid value "COMMAND_START_KDE=startkde"
> Users will not be able to request a KDE session.
> Warning: Invalid value "COMMAND_START_GNOME=gnome-session"
> Users will not be able to request a Gnome session.
> Warning: Invalid value "COMMAND_START_CDE=cdwm"
> Users will not be able to request a CDE session.
> Warning: Invalid value "COMMAND_SMBMOUNT=smbmount". You'll not be able
> to use SAMBA.
> Warning: Invalid value "COMMAND_SMBUMOUNT=smbumount". You'll not be able
> to use SAMBA.
> Warning: Invalid value "COMMAND_CUPSD=/usr/sbin/cupsd"
> Users will not be able to enable printing.
> Error: Could not find 1.5.0 version string in nxagent. NX 1.5.0 backend
> is needed for this version of FreeNX.
>
> Errors occured during config check.
> Please correct the configuration file.
>
> =============================================================
>
> Now all the warnings are fine (chose to install nx this way using only
> rdesktop to set up connections), but the error isn't oke!! Can someone
> tell me where to change what to get is show on the road?
>
> Thanks,
>
> Sander
>
> P.S. I allready set ENABLE_2_0_0_BACKEND=1 in /usr/NX/etc/node.conf
>
> ________________________________________________________________
> Were you helped on this list with your FreeNX problem?
> Then please write up the solution in the FreeNX Wiki/FAQ:
> http://openfacts.berlios.de/index-en.phtml?title=FreeNX_FAQ
> Don't forget to check the NX Knowledge Base:
> http://www.nomachine.com/kb/
>
> ________________________________________________________________
> FreeNX-kNX mailing list --- FreeNX-kNX at kde.org
> https://mail.kde.org/mailman/listinfo/freenx-knx
> ________________________________________________________________
More information about the FreeNX-kNX
mailing list