[rkward-users] [rkward:discussion] Re: RKWard 0.6.1 using R 3.0 on Ubuntu 12.04 crashing on start --rkward.frontend PID: 24582 Signal: Segmentation fault (11)

[Thomas Friedrichsmeier]

Hi!

I was just going to tell you to re-compile RKWard *after* udgrading to R 3.0.0, but in fact, your backtrace looks different.

I have found a bug that might be causing this in SVN, and fixed it. If you are building from SVN, please try again after an "svn up".

Otherwise, this problem may occur, if a "pluginmap" which was previously known to RKWard can no longer be found. You can check your ~./kde/share/config/rkwardrc for such pluginmaps, and remove them manually, or (re-) move ~./kde/share/config/rkwardrc to start with a clean setup.

However, quite likely, the reason that a previously known pluginmap file has gone missing, is that you did not install RKWard, correctly. In particular, make sure to use the correct -DCMAKE_INSTALL_PREFIX option when compiling. Note that binaries of RKWard for Ubuntu and R 3.0.0 are available since yesterday: https://launchpad.net/~rkward-devel/+archive/rkward-stable-cran .

Finally: Please don't post to both the forum and the bug-tracker. Either would have been fine in this case, but having both just increases the bookkeeping effort.

Regards
Thomas

---
[RKWard 0.6.1 using R 3.0 on Ubuntu 12.04 crashing on start --rkward.frontend PID: 24582 Signal: Segmentation fault (11)](https://sourceforge.net/p/rkward/discussion/165573/thread/8e0801f3/?limit=25#443d/2110)


---

Sent from sourceforge.net because you indicated interest in <https://sourceforge.net/p/rkward/discussion/165573/>

To unsubscribe from further messages, please visit <https://sourceforge.net/auth/subscriptions/>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mail.kde.org/pipermail/rkward-users/attachments/20130506/68f7cb40/attachment.html>