<div class="markdown_content"><p>Hi!</p>
<p>I was just going to tell you to re-compile RKWard <em>after</em> udgrading to R 3.0.0, but in fact, your backtrace looks different.</p>
<p>I have found a bug that might be causing this in SVN, and fixed it. If you are building from SVN, please try again after an "svn up".</p>
<p>Otherwise, this problem may occur, if a "pluginmap" which was previously known to RKWard can no longer be found. You can check your ~./kde/share/config/rkwardrc for such pluginmaps, and remove them manually, or (re-) move ~./kde/share/config/rkwardrc to start with a clean setup.</p>
<p>However, quite likely, the reason that a previously known pluginmap file has gone missing, is that you did not install RKWard, correctly. In particular, make sure to use the correct -DCMAKE_INSTALL_PREFIX option when compiling. Note that binaries of RKWard for Ubuntu and R 3.0.0 are available since yesterday: <a href="https://launchpad.net/~rkward-devel/+archive/rkward-stable-cran" rel="nofollow">https://launchpad.net/~rkward-devel/+archive/rkward-stable-cran</a> .</p>
<p>Finally: Please don't post to both the forum and the bug-tracker. Either would have been fine in this case, but having both just increases the bookkeeping effort.</p>
<p>Regards<br />
Thomas</p>
<hr />
<p><a class="" href="https://sourceforge.net/p/rkward/discussion/165573/thread/8e0801f3/?limit=25#443d/2110">RKWard 0.6.1 using R 3.0 on Ubuntu 12.04 crashing on start --rkward.frontend PID: 24582 Signal: Segmentation fault (11)</a></p>
<hr />
<p>Sent from sourceforge.net because you indicated interest in <a href="https://sourceforge.net/p/rkward/discussion/165573/">https://sourceforge.net/p/rkward/discussion/165573/</a></p>
<p>To unsubscribe from further messages, please visit <a href="https://sourceforge.net/auth/subscriptions/">https://sourceforge.net/auth/subscriptions/</a></p></div>