[Kst] Generate vector bug

Barth Netterfield barth.netterfield at utoronto.ca
Wed Dec 11 14:25:41 UTC 2013

I can attack this.

On December 9, 2013 11:24:28 AM Ben Lewis wrote:

> Hi Peter,
> I've got another bug for you. Here are the steps to reproduce it.
> 1. Load the 9GB file. This step is necessary because it sets a large file as
> default. Using a large file makes the bug obvious.
> 2. Close Kst.
> 3. Start Kst with a new blank session.
> 4. Generate a new vector (Create > Vector > Generate). Note the 9GB file
> should be shown greyed out in the section below "Read from Data Source"
> 5. Click OK. Kst reads the 9GB file before it creates the new vector.
> Generating a new vector should not trigger a read of the previously opened
> file. On the 32-bit version Kst crashes because it can't read the 9GB file.
> Would you like me to create a new bug report?
> Ben
> _______________________________________________
> Kst mailing list
> Kst at kde.org
> https://mail.kde.org/mailman/listinfo/kst

Barth Netterfield
University of Toronto

More information about the Kst mailing list