[Kroupware] combined use
Maarten Stolte
maarten.stolte at papuaos.org
Fri Apr 25 16:18:38 CEST 2003
On Fri, 2003-04-25 at 14:54, Dick Kniep wrote:
> Op vr 25-04-2003, om 11:09 schreef Maarten Stolte:
> > On Fri, 2003-04-25 at 10:29, Dick Kniep wrote:
> I haven't been precise in my question, so here is another try....
>
> When I want to use Webmin on a Kolab server, off course Apache should be
> running, althought there is no direct conflict between ports, I should
> run apache twice (???) and if so, I have to make sure that apache
> running "normally" (not under the kolab account) doesn't interfere with
> the kolab apache. Off course I do not wish to port the kolab php
> interface to Webmin (although this might be a nice project for the
> future). So my questions are:
>
> - Do I need to run Apache twice? (once under Kolab, once "normally")
thats easiest yes, but you could also try to make one apache serve both,
with tweaking httpd.conf
> - If I do NOT need to run Apache twice, how do I install Webmin "under
> Kolab".
add its apache config stuff to kolab's
> - If I DO need to run Apache twice, I will have to make sure that the
> "normal" Apache only listens to port 10000, otherwise it will interfere
> with Kolab. How do I do that.
read a document about apache's httpd.conf file
Does Webmin use Apache? Last time i checked it, which is, i must admit,
over 3 years back, it used some internal webserver in perl..
Maarten
More information about the Kroupware
mailing list