loading older project file using 20.12.1 fails

[Orm Finnendahl]

Hi,

 as additional note: The strace of the loading of the session gives
this:

<...> (output omitted)

write(2, "qml: loaded clip:  1443 , ID:  4"..., 58qml: loaded clip:  1443 , ID:  430 , index:  0 , TYPE: AV
) = 58
getcwd("/home/orm", 4096)               = 10
futex(0x5594dfbef3c0, FUTEX_WAIT_PRIVATE, 3, NULL) = ? ERESTARTSYS (To be restarted if SA_RESTART is set)
--- SIGWINCH {si_signo=SIGWINCH, si_code=SI_KERNEL} ---
futex(0x5594dfbef3c0, FUTEX_WAIT_PRIVATE, 3, NULL) = ? ERESTARTSYS (To be restarted if SA_RESTART is set)
--- SIGWINCH {si_signo=SIGWINCH, si_code=SI_KERNEL} ---

The last two lines get repeated ca. 30 times.

Best,
Orm

Am Mittwoch, den 03. Februar 2021 um 19:21:40 Uhr (+0100) schrieb Orm Finnendahl:
> Hi,
> 
>  using kdenlive 20.12.1, I can't open a project created with kdenlive
> 19.12.3 The program hangs during loading of clips with the progress
> bar at 88%.
> 
> The terminal (after a lot of output) shows the following last lines before
> it hangs:
> 
> <...>
> qml: loaded clip with Astream:  1
> qml: loaded clip:  46576 , ID:  437 , index:  1 , TYPE: AV
> qml: loaded clip with Astream:  1
> qml: loaded clip:  46796 , ID:  438 , index:  1 , TYPE: AV
> qml: loaded clip with Astream:  1
> qml: loaded clip:  1443 , ID:  270 , index:  2 , TYPE: AV
> 
> The project still loads fine with the old version. The computer where
> it loads fine is equipped with an intel cpu/gpu, the computer, where
> it fails, runs on an AMD ryzen architecture. But since the program
> starts up with an empty project just fine I assume it's not the
> cpu/gpu.
> 
> Is there a way how to find out what makes the program hang and maybe
> alleviate the problem?
> 
> Best,
> Orm