[Kde-hardware-devel] Solid::Control not finding local loopback

[David Hubner]

On Friday 08 Jan 2010 12:53:28 Will Stephenson wrote:
> On Sunday 27 December 2009 21:05:25 David Hubner wrote:
> > On 27/12/2009 10:19, Will Stephenson wrote:
> > > On Tuesday 22 December 2009 20:29:08 David Hubner wrote:
> > >>> What are you using it for? (That might be the use case you were looking
> > >>> for ...)
> > >>
> > >> Solid Device Viewer, its in playground, its for KInfoCenter. I am
> > >> redoing most of its KCM's over Christmas as it looks like it needs work.
> > >> I shall be moving it into kdereview after 4.4 is released. If you look
> > >> at SolDeviceTypes.cpp under the SolNetworkDevice::* you should see what
> > >> I am looking at doing :)
> > >
> > > Nice project :)
> > >
> > > Will
> > > _______________________________________________
> > > Kde-hardware-devel mailing list
> > > Kde-hardware-devel at kde.org
> > > https://mail.kde.org/mailman/listinfo/kde-hardware-devel
> > 
> > Thanks, it would be nothing if it was not for Solid :)
> > 
> > I am also just wondering about Solid::Networking::Notifier, does it send
> > a signal when a single network card changes state (eg, loses connection)
> > or only if all network cards loose access to a network?
> 
> Sorry for the delay, hopefully you'll have figured it out already, otherwise:
> 
> Solid::Networking::Notifier signals system-wide 'online status'.
> 
> Solid::Control::NetworkInterface (and subclasses) signal individual network 
> cards state.
> 
> Will
> _______________________________________________
> Kde-hardware-devel mailing list
> Kde-hardware-devel at kde.org
> https://mail.kde.org/mailman/listinfo/kde-hardware-devel
> 

Thanks, i have been playing around with it. I have been trying to connect to every networkinterfaces ipDetailsChanged() signal by doing 

  QList<Solid::Control::NetworkInterface *> nicList = Solid::Control::NetworkManager::networkInterfaces();
  
  foreach(Solid::Control::NetworkInterface *nic, nicList) {
    kDebug() << "Connecting " << nic->uni() << endl;
    connect(nic,SIGNAL(ipDetailsChanged()),this,SLOT(nicChangedSignal()));
  }

For some reason it does not complain about the slot or signal not being there ( because they are ) but it does not work. Its probably something stupid i am doing :)  

Thanks
-- 
David Hubner
IRC: hubnerd
MSN: hubnerd at hubnerd.org
ICQ: 24308559