[Kde-hardware-devel] Solid::Control not finding local loopback

[Will Stephenson]

On Sunday 27 December 2009 21:05:25 David Hubner wrote:
> On 27/12/2009 10:19, Will Stephenson wrote:
> > On Tuesday 22 December 2009 20:29:08 David Hubner wrote:
> >>> What are you using it for? (That might be the use case you were looking
> >>> for ...)
> >>
> >> Solid Device Viewer, its in playground, its for KInfoCenter. I am
> >> redoing most of its KCM's over Christmas as it looks like it needs work.
> >> I shall be moving it into kdereview after 4.4 is released. If you look
> >> at SolDeviceTypes.cpp under the SolNetworkDevice::* you should see what
> >> I am looking at doing :)
> >
> > Nice project :)
> >
> > Will
> > _______________________________________________
> > Kde-hardware-devel mailing list
> > Kde-hardware-devel at kde.org
> > https://mail.kde.org/mailman/listinfo/kde-hardware-devel
> 
> Thanks, it would be nothing if it was not for Solid :)
> 
> I am also just wondering about Solid::Networking::Notifier, does it send
> a signal when a single network card changes state (eg, loses connection)
> or only if all network cards loose access to a network?

Sorry for the delay, hopefully you'll have figured it out already, otherwise:

Solid::Networking::Notifier signals system-wide 'online status'.

Solid::Control::NetworkInterface (and subclasses) signal individual network 
cards state.

Will