[FreeNX-kNX] Load balancing with FreeNX

[Rajesh Kumar Mallah]

Prakash Velayutham wrote:
> Hello,
>
> Could someone here explain how to configure load balancing in FreeNX? I
> have followed the document and setup my main FreeNX entry server and the
> load-balanced FreeNX servers behind it. But I see some issues. My setup
> is on OpenSUSE-10.2, NX-1.5.0-73, FreeNX-0.6.
>
> Here is a relevant portion of node.conf.
>
>
> SERVER_LOADBALANCING="Yes"
>
> LOAD_BALANCE_SERVERS="headnode.chmccorp.cchmc.org cellulose.cchmc.org"
>
> LOAD_BALANCE_ALGORITHM="round-robin"
>   

Some hints.
1. increase log verbosity
2. while u connect  tail -f /var/log/nxserver.log

observe for the messages see whats going on.
(i hope u already doing that).

Its basically possible and we have a load balanced
setup using FreeNX 0.6.

u also need a shared storage for the session data
i hope u taking care of that.

we have however used the "load" algo which is bit
complex setup.

all the best.

regds
mallah.


> Thanks,
> Prakash
>
> ________________________________________________________________
>      Were you helped on this list with your FreeNX problem?
>     Then please write up the solution in the FreeNX Wiki/FAQ:
>   http://openfacts.berlios.de/index-en.phtml?title=FreeNX_FAQ
>          Don't forget to check the NX Knowledge Base:
>                  http://www.nomachine.com/kb/ 
>
> ________________________________________________________________
>        FreeNX-kNX mailing list --- FreeNX-kNX at kde.org
>       https://mail.kde.org/mailman/listinfo/freenx-knx
> ________________________________________________________________
>
>