[FreeNX-kNX] Negotiating Link Parameters

jim tate mickeyboa at sbcglobal.net
Wed Jul 25 16:52:38 UTC 2007


Terje Andersen wrote:
> jim tate wrote:
>   
>> Running NX on a remote client that worked fine. until,
>> I installed a Linksys WRT54G router in front of the remote client and 
>> did a "Port Forwarding"
>> in the Linksys to the remote client, and I can communicate perfectly 
>> with remote client using SSH -X in Linux, Both Computers are Fedora 
>> Linux, but when I run NX to connect, it says
>> "Authenticating Completed" then when it says it is "Negotiating Link 
>> Parameters"
>> and it fails to connect.
>>     
> can you double-check that you have enabled SSL in the client? if that 
> isn't the fault, you need to send logs :-)
>
> /Terje
> ________________________________________________________________
>      Were you helped on this list with your FreeNX problem?
>     Then please write up the solution in the FreeNX Wiki/FAQ:
>   http://openfacts.berlios.de/index-en.phtml?title=FreeNX_FAQ
>          Don't forget to check the NX Knowledge Base:
>                  http://www.nomachine.com/kb/ 
>
> ________________________________________________________________
>        FreeNX-kNX mailing list --- FreeNX-kNX at kde.org
>       https://mail.kde.org/mailman/listinfo/freenx-knx
> ________________________________________________________________
>
>   
Yeah SSL solved the problem, Thanks very much.

Jim



More information about the FreeNX-kNX mailing list