[Digikam-users] Exiv2 library missing???

Daniel Bauer linux at daniel-bauer.com
Wed Dec 6 13:21:51 GMT 2006


On Wednesday 06 December 2006 12:18,  Fabien wrote:
> Hello,
>
> I saw that it works if you remove the exiv2-0.11 in /opt
> Now that you reinstalled it, we can continue
> I hope you didn't remove the files used for compilation.
>
> So, here are the steps :
>
> 1) use my run_configure.sh.txt script to just start the configure
> (instead of compile_digikam).
>
> You should still get the same errors (or it would make no sense if you
> have again the same configuration)

yes, output is here:
http://www.daniel-bauer.com/test/run_configure.out.txt
>
> 2) if you get the errors, try to replace your graphics/configure by
> the configure.txt I sent you.
> This will output some debugs.

i hope I understood correctly:
- renamed graphics/configure to ... .old
- copied your configure.txt into graphics folder, renamed it to configure, 
made it executable
- run run_configure.sh again

output is here:
http://www.daniel-bauer.com/test/run_configure_Fab.out.txt
>
> 3) reports all results to the list

is this what you wanted?
>
> We'll find the solution :)
>
> Thanks.
>
> --
> Fabien

thank *you*

Daniel
-- 
Daniel Bauer photographer Basel Switzerland
professional photography: http://www.daniel-bauer.com
Madagascar special: http://www.sanic.ch



More information about the Digikam-users mailing list