[Digikam-devel] [Bug 215657] raw import tool does not use general digikam settings

[S. Burmeister]

https://bugs.kde.org/show_bug.cgi?id=215657





--- Comment #5 from S. Burmeister <sven burmeister gmx net>  2009-11-26 10:46:36 ---
Still valid for Rev: 1054504

To reproduce do the following:

1. close digikam and move the ~/.kde4/share/config/digikamrc. all configs
should be gone.

2. Open digikam and tell the wizard to NOT import RAW images automatically but
ask the user for the settings.

3. Open digikam's settings, go to the RAW decoding section. Set the quality to
AHD, disable "automatic brigthenss" and enable the noise reduction. click OK.

4. Quit digikam and re-open, to make sure it reads the new settings. Open
digikam's settings and check that the changes are still there.

5. Open a RAW image in the editor and have a look at the RAW import utility
settings in the pane on the right-hand side. Quality is set to "bilinear"
rather than AHD. "Automatic brightness" is enabled rather than disabled and
noise reduction is disabled rather than enabled.

Digikam fails to apply the default settings whenever it performs raw decoding.

-- 
Configure bugmail: https://bugs.kde.org/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are the assignee for the bug.