[Kwintv] No control of BT878 Device

[Algenon]

Hi, I have installed a Flyvideo '98 FM card and kwintv-0.8.5 from an RPM on 
my RH7.2 and KDE 2.2 dual processor box.  All went well and the Kwintv screen 
comes up ok but when I try to set the channels using the wizard, it steps 
right through the band and finds nothing.  I do not know if I need to set 
some config file.  The card was detected and installed ok on startup.  Can 
someone see what I am doing wrong?

This is the output from 'dmesg'

Linux video capture interface: v1.00
i2c-core.o: i2c core module
i2c-algo-bit.o: i2c bit algorithm module
bttv: driver version 0.7.72 loaded
bttv: using 2 buffers with 2080k (4160k total) for capture
bttv: Host bridge needs ETBF enabled.
bttv: Bt8xx card found (0).
bttv0: Bt878 (rev 17) at 00:0b.0, irq: 17, latency: 32, memory: 0xe1000000
bttv0: model: BT878( *** UNKNOWN *** ) [autodetected]
bttv0: enabling ETBF (430FX/VP3 compatibilty)
i2c-core.o: adapter bt848 #0 registered as adapter 0.
bttv0: i2c: checking for MSP34xx @ 0x80... not found
bttv0: i2c: checking for TDA9875 @ 0xb0... not found
bttv0: i2c: checking for TDA7432 @ 0x8a... not found
i2c-core.o: driver i2c TV tuner driver registered.
tuner: chip found @ 0xc2
bttv0: i2c attach [(unset)]
i2c-core.o: client [(unset)] registered to adapter [bt848 #0](pos. 0).

I do not know what can be done to test my setup, if anything.

Colin