Changing indent size

[John A. Sullivan III]

Ah! I should have seen that! I feel like I'm taking one of those trick
IQ tests where they distract you with the erroneous obvious! I looked
right at it but was distracted by indentation.  Thank you, thank you,
thank you - John

On Thu, 2004-03-04 at 13:07, David Sibai wrote:
> Ahaa... I found it, and I have to admit it's not straightforward at all:
> 1.  Settings->Configure Editor->Editing, and in the "Tabulator" group you'll 
> find the "tab width" settings
> 2. Make sure pressing <tab> will actually insert tab characters:
> Settings->Configure Editor->Indentation and in the "Tab key mode if nothing 
> selected" group, check "insert tab character".
> I'd rather have the tab configuration in the indentation group...
> 
> David
> On Thursday 04 March 2004 05:13, John A. Sullivan III wrote:
> > That's where it used to be! Now it looks like the only way to do it is
> > to replace tabs with spaces and set the number of spaces.  I'm a little
> > hesitant to do that; I would prefer to change the tab size.  Is that
> > what you see in your KDevelop?
> 
> -
> to unsubscribe from this list send an email to kdevelop-request at kdevelop.org with the following body:
> unsubscribe your-email-address
-- 
John A. Sullivan III
Chief Technology Officer
Nexus Management
+1 207-985-7880
john.sullivan at nexusmgmt.com


-
to unsubscribe from this list send an email to kdevelop-request at kdevelop.org with the following body:
unsubscribe »your-email-address«