Enable debug in project options

[Bernd Pol]

Hi,

I experienced this recently, too. It turns down obviously to an automake 
misbehaviour. If you ever compiled with the project options "default" 
tab some internal directory settings (if I remember right) get in 
disorder, and the "default" tab won't ever work again. 

I had to clean and distclean and even did a
	make -f admin/Makefile.common cvs-clean
to get my project back to a virgin state. Then I compiled in the 
"default" tab only and everything ran fine again.

For non-debug purposes I did set up a "standard" tab in the project 
options. This works as well as "default" without screwing things up.

Hope, this helps
Bernd

On Sunday 21 September 2003 18:14, cantabile wrote:
> Hi again everybody,
> I'm trying to compile my project with debug options enabled. I found
> a tab in 'project options' for this.
> But my program won't configure/compile in this case : I get most
> often the error code 1, without explanation.
> Are there includes I should add to my program (I noticed error 1
> often happens with missing includes) ?


-
to unsubscribe from this list send an email to kdevelop-request at kdevelop.org with the following body:
unsubscribe »your-email-address«