[Kde-hardware-devel] Solid::Control not finding local loopback

David Hubner hubnerd at ntlworld.com
Sun Dec 27 21:05:25 CET 2009


On 27/12/2009 10:19, Will Stephenson wrote:
> On Tuesday 22 December 2009 20:29:08 David Hubner wrote:
>    
>>> What are you using it for? (That might be the use case you were looking
>>> for ...)
>>>        
>> Solid Device Viewer, its in playground, its for KInfoCenter. I am
>> redoing most of its KCM's over Christmas as it looks like it needs work.
>> I shall be moving it into kdereview after 4.4 is released. If you look
>> at SolDeviceTypes.cpp under the SolNetworkDevice::* you should see what
>> I am looking at doing :)
>>      
> Nice project :)
>
> Will
> _______________________________________________
> Kde-hardware-devel mailing list
> Kde-hardware-devel at kde.org
> https://mail.kde.org/mailman/listinfo/kde-hardware-devel
>
>    
Thanks, it would be nothing if it was not for Solid :)

I am also just wondering about Solid::Networking::Notifier, does it send 
a signal when a single network card changes state (eg, loses connection) 
or only if all network cards loose access to a network?

Thanks


More information about the Kde-hardware-devel mailing list