[kde-freebsd] Re: kde4 fails to start after update.

[Mike Barnard]

On Thu, Nov 11, 2010 at 6:27 PM, Raphael Kubo da Costa <kubito at gmail.com>wrote:

> >
> > If you're using 8-STABLE, you need to remove the xz port and use xz from
> > base, which has had a library bump too; otherwise, the same applies to
> the
> > xz port.
>
>
Yes I am using 8-STABLE. xz from stable was not there... for some reason,
after the upgrade, all its libraries were trashed (I am puzzled as to why
that would happen, may be I did something wrong... I'll trace everything I
did for the upgrade and look for anything wrong I may have done). I have
reinstalled xz from ports, its faster than rebuilding the kernel, and
symlinked liblzma.so.0 to liblzma.s0.5 and all seems to be good...


> (and then recompile kdelibs4)
>
after the symlinks were done, I rebooted and KDE loaded... this is a bad
hack to get it to work, but I needed this up ASAP. I'll get it rectified
properly later.



-- 
Mike

Of course, you might discount this possibility, but remember that one in
a million chances happen 99% of the time.
------------------------------------------------------------
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mail.kde.org/pipermail/kde-freebsd/attachments/20101111/d9b005ca/attachment.htm