[FreeNX-kNX] NX 2.0.0 on x86_64. How?

[Jon Scruggs]

As far as I know, you cannot build the NX components using 64 bit
mode. You can compile it if the whole system is compiled 32 bit,
though. You can just download the nxclient and nxnode RPMs from
NoMachine, then install FreeNX. However, you need to have the 32 bit
emulation stuff installed. I don't know what they are called on
OpenSuse.

Cheers.

On 7/21/06, EI <geneing at gmail.com> wrote:
> Has anyone built NX on 64bit Linux? Could someone post the instructions.
>
> I get this when I compile nx-x11:
> XlcDL.c:64:4: error: #error "Unknown architecture"
>
> I use opensuse 10.1 and I can't find prebuild binaries.
>
> Thanks,
> Eugene
>
> ________________________________________________________________
>     Were you helped on this list with your FreeNX problem?
>    Then please write up the solution in the FreeNX Wiki/FAQ:
> http://openfacts.berlios.de/index-en.phtml?title=FreeNX_FAQ
>         Don't forget to check the NX Knowledge Base:
>                 http://www.nomachine.com/kb/
>
> ________________________________________________________________
>       FreeNX-kNX mailing list --- FreeNX-kNX at kde.org
>      https://mail.kde.org/mailman/listinfo/freenx-knx
> ________________________________________________________________
>
>