[Digikam-users] Canon EOS 6D

[Bob]

It seems strange that both Dolphin and Gwenview can access the camera 
but Digikam can't?

Bob


> Try to report this problem to KDE Solid team. It's possible that it's
> a side effect of a low level component from your distro...
>
> Gilles Caulier
>
> 2014-04-24 11:33 GMT+02:00 Bob <bobd at wtaustralia.com>:
>> Thanks again Gilles,
>>
>>
>>> Well, more in the deamon which mount the device in fact. the original
>>> message :
>>>
>>> 'The specified camera
>>>
>>> ("/org/kde/solid/udev/sys/devices/pci0000:00/0000:00:0f.3/usb1/1-8/1-8:1.0")
>>> is not supported.'
>>>
>>> do not come from digiKam as well, but from KDE Solid interface...
>> OK - if this is the case where should I go to for resolution of the problem?
>> It is strange that this hasn't affected others?
>>
>> Thanks
>>
>> Bob
>>
>>
>>
>>> Gilles Caulier
>>>
>>> 2014-04-24 11:18 GMT+02:00 Bob <bobd at wtaustralia.com>:
>>>> Hello Again Gilles,
>>>>
>>>>
>>>> On 24/04/14 15:38, Gilles Caulier wrote:
>>>>> Problem is relevant of Gphoto2 shared library used by digiKam to
>>>>> transfert images from Canon Camera.
>>>>>
>>>>> Ask to Gphoto2 team.
>>>> They have referred me back to Digikam.  It would appear that the Gphoto2
>>>> shared library may not be the problem as using the command line command:
>>>> gphoto2 -P   the camera is accessed and the images are downloaded
>>>> correctly.
>>>> The problem may be with KDE/Digikam?
>>>>
>>>> Thanks
>>>>
>>>> Bob
>>>>
>>>>
>>>>>> Hello,
>>>>>> I have been using Digikam for some years but now find that the latest
>>>>>> version ( 3.5.0) doesn't appear to recognise my camera. Using 3.4.0 my
>>>>>> Canon
>>>>>> EOS 6D is recognised and I can transfer images OK, but the latest
>>>>>> version
>>>>>> gives the message:
>>>>>> 'The specified camera
>>>>>>
>>>>>>
>>>>>> ("/org/kde/solid/udev/sys/devices/pci0000:00/0000:00:0f.3/usb1/1-8/1-8:1.0")
>>>>>> is not supported.'
>>>>>>
>>>>>> Thanks for any help
>>>>>>
>>>>>> Bob
>>>>>>