[Digikam-devel] [digikam] [Bug 320016] Full-screen options are not applied after restarting digikam

[Romain Henriet]

https://bugs.kde.org/show_bug.cgi?id=320016

--- Comment #7 from Romain Henriet <romain.pub at laposte.net> ---
Light table in full-screen view : toolbar, thumbbar and (In reply to comment
#5)
> (In reply to comment #3)
> > Ah the problem is different. Settings is stored and restored between
> > session. But you want to see digiKam started in fullscreen mode as well ?
> > 
> > If yes, as i rewritten and factored all code relevant to fullscreen mode, i
> > see a lots of GUI problem to start in fullscreen mode directly an
> > application. Especially under OSX, digiKam GUI is completely broken. Under
> > Linux, it's less catastrophic but not perfect.
> 
> I think the problem is slightly different as you describe here.
> My current settings for full-screen view:
> [ ] Hide toolbars
> [x] hide thumbbar
> [x] hide sidebars
> 
> 1. Start digikam ( get into album view from my select ed album)
> 2. enter full-screen view:
>  * sidebars are shown and opened
>  * toolbar is shown
>  * thumbbar is hidden
> 3. quit fullscreen & enter digikam configuration
> 4. change nothing (!) and press 'OK'
> 5. enter full-screen again:
>  * sidebars hidden
>  * toolbar is shown
>  * thumbbar is hidden
> 
> The effects a smaller than the ones Romain described in comment #1 because
> my toolbar and thumbbar settings match the ones digikam picks. But the
> sidebar setting is wrong after startup until i store/set a new one in the
> configuration.
> It appears to me that digikam doesn't load the saved configuration properly.
> Noticed this on Digikam 3.2.0 on Gentoo, while Digikam 3.1.0 in Arch doesn't
> show this behavior. Might be caused by the fact that full-screen settings
> just came with 3.2.

Yes that's exactly the same for me, I may not have been clear enough in #1

-- 
You are receiving this mail because:
You are the assignee for the bug.