[Digikam-devel] extragear/graphics/digikam

[Andi Clemens]

I will remove debug.h, and keep the area codes in config-digikam.h, if we ever 
want to use them manually.

Andi

On Thursday 29 October 2009 01:59:27 Andi Clemens wrote:
> SVN commit 1042050 by aclemens:
> 
> Put debug area codes into config-digikam.h, just in case we want to specify
>  an area code manually sometimes.
> The question is should we change all the code again and remove debug.h, or
> should we move the defines in here into debug.h and just keep it this way?
> It will save us some work now, but in general debug.h is not needed
>  anymore.
> 
> If we want to remove it, I will volunteer to do this nasty job, the regexps
>  are already set up ;-)
> 
> CCMAIL:digikam-devel at kde.org
> 
>  M  +7 -0      config-digikam.h.cmake
> 
> 
> --- trunk/extragear/graphics/digikam/config-digikam.h.cmake
>  #1042049:1042050 @@ -22,4 +22,11 @@
>  /* Define to 1 if you have Nepomuk shared libraries installed */
>  #cmakedefine HAVE_NEPOMUK 1
> 
> +
> +/* debug area codes */
> +#define AREACODE_GENERAL        ${AREA_CODE_GENERAL}
> +#define AREACODE_KIOSLAVES      ${AREA_CODE_KIOSLAVES}
> +#define AREACODE_SHOWFOTO       ${AREA_CODE_SHOWFOTO}
> +#define AREACODE_IMAGEPLUGINS   ${AREA_CODE_IMAGEPLUGINS}
> +
>  #endif /* CONFIG_DIGIKAM_H */
> _______________________________________________
> Digikam-devel mailing list
> Digikam-devel at kde.org
> https://mail.kde.org/mailman/listinfo/digikam-devel
>