[Digikam-devel] [Bug 217555] "Cannot display preview" error when browsing

[DGardner]

https://bugs.kde.org/show_bug.cgi?id=217555





--- Comment #3 from DGardner <dkde gardnersworld org>  2009-12-23 16:31:40 ---
Same problem with digiKam 1.0.0-rc1--it just happened right now
with some files that I had newly imported. These are full size
15MP JPEG files from a Canon 50D, about 3-7MB each.

Sometimes the message is shown and a few seconds later the image
appears; other times, the image never appears and the message
remains. Right now, with these new images, it is a mix of both
(when it does not work first time).

On this particular set of images, the message appears for about
15% of them and remains for about 10% of them, which is about
average in my experience. When I reported the original bug, I
had a set of images where I was getting the message much more
frequently. It seems to happen mostly to new images. However,
most of my new images are from a new 50D that produces files
that are larger than any other camera I have owned, so maybe
the extra time taken to load them is causing some kind of
time-out. That might explain some of the behaviour, though
often a 7MB image will be fine and a following 4MB image
will not be shown on the first attempt.

I don't know what "50003 enabled in kdebugdialog" means, but I
ran digiKam from the console just now and nothing was reported
at the point that the message appeared instead of the image.

-- 
Configure bugmail: https://bugs.kde.org/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are the assignee for the bug.