[Digikam-devel] [Bug 215657] raw import tool does not use general digikam settings

[S. Burmeister]

https://bugs.kde.org/show_bug.cgi?id=215657





--- Comment #12 from S. Burmeister <sven burmeister gmx net>  2009-12-07 18:49:28 ---
(In reply to comment #10)
> Let me find out if anything here is critical for the 1.0 release:
> 
> I open a raw, and change settings in the raw decoding tool. Then I import. For
> the next RAW image the settings in the raw decoding tool are remembered as I
> just changed them.

Until one closes digikam/the editor, yes that works as expected. Except that at
some point it did not not start with the digikam settings when you open the
editor the first time after you opened digikam. Yet I cannot reproduce that at
the moment.

> The settings from the Configure dialog do not influence these settings.

AFAIK they should, i.e. be the values the editor uses when it is opened the
first time.

> The BQM raw import uses the settings from the setup dialog.

No, it ignores automatic brightness, i.e. enables it although it is disabled in
the setup dialogue.

It also ignores denoise, which I set to 1000 in the setup dialogue in order to
test.

I bet it also ignores the nebaled 16bit and quality and uses bilinear instead
of AHD but that's a bit hard to test.

I have not tested whether it ignores other settings from the setup dialogue as
well.

-- 
Configure bugmail: https://bugs.kde.org/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are the assignee for the bug.