[FreeNX-kNX] FreeNX LoadBalancing

[Jean Milot]

Hello,

It is easy to configure LoadBalancing and Forwarding.

You need to edit the /etc/nxserver/node.conf for specify your hosts.

Don't forget the /usr/bin/nxcheckload (if you need)

Sincerely,

Jean

Jean Milot  - jmilot at dotriver.eu - www.dotriver.eu<http://www.dotriver.eu/>
5 passage de l'avenir, F-69200 Vénissieux
Fixe: +33 (0)4 27 46 39 80 Hotline: # 89  Fax: # 81

Rencontrez DotRiver : Salon Use-IT 2012 (http://bit.ly/IV8U81),
Festival Temps Libre (http://bit.ly/L6YbwD)
DotRiver, membre du consortium "nuage" (http://bit.ly/LNIfMr)

Pas à pas, agissons au quotidien pour préserver notre environnement. N'imprimez que si nécessaire, réduisez les déchets informatiques et économisez l'énergie en utilisant les solutions DotRiver.


Le 24/09/2012 16:56, Jamie Fargen a écrit :
> Hello,
>
> I am running CentOS 6.2 w/Gnome and I have installed and setup FreeNX 
> on two servers. I have no problems with the basic config as installed 
> through yum. Now I would like to configure NX to use load balancing 
> and forwarding between these two hosts. At this point there seems to 
> be an issue with the ssh keys.
>
> Regards,
>
> Jamie I. Fargen
>
>
> ________________________________________________________________
>       Were you helped on this list with your FreeNX problem?
>      Then please write up the solution in the FreeNX Wiki/FAQ:
>
> http://openfacts2.berlios.de/wikien/index.php/BerliosProject:FreeNX_-_FAQ
>
>           Don't forget to check the NX Knowledge Base:
>                   http://www.nomachine.com/kb/
>
> ________________________________________________________________
>         FreeNX-kNX mailing list --- FreeNX-kNX at kde.org
>        https://mail.kde.org/mailman/listinfo/freenx-knx
> ________________________________________________________________
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mail.kde.org/pipermail/freenx-knx/attachments/20120924/eca10394/attachment.html>