<div dir="ltr">Hi folks.<div><br></div><div>I'm starting looking at DigiKam, and I'm facing a behavior for which I need support.</div><div><br></div><div>I'm on MacOS. My photos are on an USB SSD that I plug into the laptop when I need to work on them. I set this disk as removable folder in the DigiKam settings.</div><div><br></div><div>Well, if I unplug the disk and trigger a refresh on an album living on it, the whole collection disappears from the DigiKam's album pane, and in no way I can recover it even if I relaunch DigiKam with the SSD plugged in. I've to turn back to the settings and re-link the USB as removable folder; but now DigiKam starts scanning the driver from scratch, as if the driver hasn't been never connected.</div><div><br></div><div>Honestly, it's quite dangerous: I can hopelessly lose the entire scan just triggering a refresh forgetting the driver is disconnected, and I've to wait (once again, a lot of time) for a new whole scan to finish.<br></div><div>The only workaround I found so far is to set the removable disk as network shared folder... but it's seems strange to me.</div><div><br></div><div>Is it the intended behavior? Or am I missing something?</div><div><br></div><div>Thank you for the support.</div><div><br></div><div>Bye</div><div>Luca</div><div><br></div></div>