<div dir="ltr"><div>Hi,<br></div><div><br></div><div>Run the AppImage from a console to list debug trace enable previously with a shell variable as explained here :</div><div><br></div><div><a href="https://www.digikam.org/contribute/">https://www.digikam.org/contribute/</a></div><div><br></div><div>You must be able to found the item which generate an exception in the program.</div><div><br></div><div>Best</div><div><br></div><div>Gilles Caulier<br></div></div><br><div class="gmail_quote"><div dir="ltr" class="gmail_attr">Le sam. 5 févr. 2022 à 22:52, Jay <<a href="mailto:jay@speedpost.net">jay@speedpost.net</a>> a écrit :<br></div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex"><u></u><div><div style="font-family:Arial">Hello,<br></div><div style="font-family:Arial"><br></div><div style="font-family:Arial">After a clean install of Linux Mint 20.3, I copied my duplicated digiKam database from my cloud storage onto my hard disk, including database files. When I start up 7.5.0 Appimage, the check for new items takes 6 seconds to reach 98% complete, and hangs at that point. After about 11 seconds the program quits with no messages.<br></div><div style="font-family:Arial"><br></div><div style="font-family:Arial">This repeats every time I tried to run digiKam, so I deleted the database files and started digiKam once more. It spent a long time rebuilding the database, and apparently crashed at 98%. Subsequent attempts to run the program gives the same result, software just quits at 98%.<br></div><div style="font-family:Arial"><br></div><div style="font-family:Arial">Any suggestions where to go from here would be most appreciated.<br></div><div style="font-family:Arial"><br></div><div style="font-family:Arial">Jay Rutherford<br></div><div style="font-family:Arial"><br></div></div></blockquote></div>